^® Impulse ^tm TrimMaster^tm
Cordless Angled Finish Nailer

• Anywhere a compressor and its hoses are impractical or impossible.
• For Remodeling or New Construction: Door Jambs / Stops, Base Shoe, Baseboard Moldings, Chair Rails, Paneling, Window Casings, Crown Moldings, Cabinetry, anywhere one can not risk even a single hammer dent. The time this tool can save you from re-cutting a very visible , yet damaged, trim piece; will help this tool pay for itself.

FEATURES

• Cordless / Compressor less operation: This nailer is powered by an internal combustion motor: simply load a fastener clip, its fuel cell and its rechargeable battery and this tool is ready to pound in nails.
• Light weight: 4.9 lbs. allows one to work all day with less arm fatigue. You will appreciate its light weight, overall balance and textured "sure-grip" handles.
• Heavy duty battery: This unit will provide approximately 4,000 cycles per charge.
• Mobility: We can not over emphasize this units portability. Since it needs no compressor this unit allows movement throughout the job without any restrictions.
• Tackles Tight Spots: The compact angled design of the magazine lets one work comfortably in cramped, overhead or other hard-to-reach places.
• Non-Mar Tip: The no-mar tip allows delicate and fine work to be fastened without leaving any marks.
• State-of-the-art Electronics: Reliable , consistent long-life ignition. No break-in period.
• Powerful Heavy Duty Motor: Drives from 1 ^1/4" to 2 ^{1/2 "} nails into the hardest woods. Versatile. A wide variety of finish applications with just one tool.
• Lockout Feature: Locks out tool at 10 nails to prevent blank firing and damage to wood surfaces.

Tool Specifications*

Model	Cordless Angled Finish Nailer (part # 900600)
Weight	4.9 lbs.
Dimensions	Height = 111/2 " by Length = 10 3/4"
Load Capacity	2 strips, approximately 100 Nails
Fastener Specifications	Lengths: 1 1/4" to 2 1/2 " Shank Diameters: 16 gauge Shank Configuration: Smooth Coatings: Galvanized. * *The Impulse Cordless Finish Nailer is not recommended for use at altitudes above 5,000 feet or in temperatures below 20 o F / -7 o C.

^*Due to our continuous efforts to improve the quality of our products, the specifications and design of the products on this site are subject to change without notice.

This page is copyrighted © 1997-1998 by Duo-Fast Northeast and Third Millennium Marketing, LLC ® . All rights both domestic and international reserved. The Paslode logo and name are registered trademarks of Paslode ® An Illinois Tool Works Company, Vernon Hills, Illinois.